From the IaaS server(s), Go to the vRealize Automation Appliance installation site at “https://FQDN of vRealize Automation:5480/i” and download the “IaaS installer”.
Following setup file has downloaded. Right-click the IaaS Installer and run it as Administrator.
NOTE: do not rename the setup file.
Installation wizard started -> Click “Next”
Accept the license Agreement -> Click “Next”
Use your “vRealize Automation Appliance” root account and password and click “Accept certificate” checkbox. click “Next”.
Installation Type: Choose the default “Complete setup and click “Next”.
NOTE: In production you may install each IaaS component on different system depend upon on your environment.
Verify Prerequisites: Verify and fix any problem prerequisites and click “Next”.
Server and Account Settings:
Fill in your vRealize Automation service account information (in my case, I am using my service account “iaas-srv”), a “passphrase” (take note of this, as you are unable to reinstall anything later without it).
Enter the “SQL server FQDN” and a new “database name” that is be created. Keep the Use “Windows Authentication”. Because, I am using my service account “iaas-srv” as windows login for IaaS components installation –> Click “Next”
NOTE: In Express Edition Use Server name (FQDN/Express).
Distributed Executions Managers and Proxy vSphere Agent:
I have changed the endpoint name into”vc01”, Ofcourse you can leave it as default. (This endpoint, I will used later in vRealize Endpoint configuration) and leave the reset of settings as default -> click “Next”.
NOTE: you should remember the endpoint name which you defined in that Wizard configuration. Because endpoint name must be the same as you defined here, when you do your End point configuration later in vRealize Endpoint configuration.
Click on “Load” to load the default “vsphere.local” tenant. Click on “Download” to pull in the vRealize Automation certificate. Select “Accept Certificate”. Enter the “firstname.lastname@example.org” account information for the SSO Administrator Credentials. Verify that the “IaaS Server” is set as your “local FQDN” and click “Next”.
Now installation has been started. It took 5-10 minutes to complete depend upon the environment.
If everything went well then you got the below screen “installation completed” -> Click “Next”
If you want to start configuring the “initial system configuration” then leave the “checkbox checked” and click “finish”